Cliff's Quadrajet Parts and Rebuild Kits

General Category => Quadrajet Carb Talk and Tips => Topic started by: Mr.Pontiac on June 24, 2011, 12:30:23 PM

Title: secondary fuel nozzle question
Post by: Mr.Pontiac on June 24, 2011, 12:30:23 PM

I was wondering whats the best way of pulling them out?? Just tryed to remove a set and distorted them, need a new set and found tubing exact same o.d. and inside dia. How can i part them off to the correct length??

Title: Re: secondary fuel nozzle question
Post by: Cliff Ruggles on June 26, 2011, 05:14:34 AM

Removal is easy.  I slip a punch inside them and go in a circular motion and they fall right out.

Brass replacments are best, driven in with some red loctite on them.  Tubing cutter should cut the brass tubing, but the ends will need de-burred....Cliff