Cliff's Quadrajet Parts and Rebuild Kits
Quadrajet Problem Solving => Buy Quadrajet Parts, Quadrajet Kits, Service => Topic started by: leroy on November 17, 2011, 04:50:12 AM
-
First time poster long time lurker based in Western Australia
Own a 73 corvette 454 4 speed
Have read your book a few times now have a working carb plus another i am ripping parts off
Cliff have you thought of producing your guage to enable us to buy to play with different hanger hieghts or is there a chart somewhere to read
If there is is it measured from the base of the hanger or from inside edge where the hanger sits on the carrier to the holes
Cheers
-
Many years ago (at least 25), I made a gauge from a piece of flat steel. I drilled holes for the "B" hanger, "G" hanger and "P" hanger. These days I don't look around for different ones, I just gently bend what I've got to fall in where I want it.....Cliff
-
Hi Cliff
Yes I remember reading this in a previous thread hence the question
CAn you reproduce these for sale or direct me to a table that givees these hieghts along where exactly to measure to and from
Cheers
-
ok bit of searching found you measure between inside hanger where it sits on the carrier that rides the cam connected to the airflap to the hole for the rods
B hanger is 520 thou
G hanger is 545 thou
P hanger is 590 thou
gotta love google
so there you go should of checked first i guess b4 posting the ? 8)
-
Righto apologies to Cliff
should of read the edelbrock section in the quadrajet bible more closely
pg121 a pic of the spec sheet for calibration kit and guess what?
measurements for the hangers and where to measure ::)
Soo not hard to make up my own gauge ;D
-
Amazing there was twenty different hangers produced!!! B to V