« previous next »
Pages: [1]   Go Down

Author Topic: M4MED Function  (Read 3275 times)

Offline kiowamec

  • Newbie
  • *
  • Posts: 3
M4MED Function
« on: May 05, 2009, 12:05:33 AM »
Okay I finally got my M4MED stripped down. Man there is quite a few parts inside these carbs.

Studying the booster circuit it appears that the solenoid operation simply diverts fuel from the pump back to the fuel bowl. This setup seems to be more of a reducer of pump shot rather than a double pump shot as the model signifies.

Can someone confirm this shed some light on this?
Logged

Offline Schurkey

  • Carb lover
  • ***
  • Posts: 157
Re: M4MED Function
« Reply #1 on: May 06, 2009, 12:40:58 AM »
Chevy engine in a pickup truck or van; early-to-mid-'80s; electrical connector on the carb but not computer controlled?

Yeah, that's the way I understood them to work.  Cold engine gets full pump shot, warm engine gets reduced pump shot.

Maybe I'm wrong.
Logged
Demand compensation from Communist China for the damage done by the Virus Originating in the Wuhan Lab, released (intentionally or negligently) into the world in 2019 (VOWL-19).  Trillions of dollars, plus direct compensation to individuals for medical bills, and "wrongful death" settlements.

Offline Cliff Ruggles

  • Administrator
  • Qjet Hero
  • *****
  • Posts: 5418
Re: M4MED Function
« Reply #2 on: May 06, 2009, 10:26:50 AM »
That's pretty much how they work.  We use a lot of those castings to build our custom large cfm carbs from.  That system can be blocked off internally and a standard late model airhorn installed on them......Cliff
Logged

Offline kiowamec

  • Newbie
  • *
  • Posts: 3
Re: M4MED Function
« Reply #3 on: May 07, 2009, 11:59:11 AM »
The solenoid does operate on 12 volts correct?
I think I will leave it in and put it on a switch.
I will be using a Wide-band to set it up so I will be able to see what works best.
Logged
Pages: [1]   Go Up
« previous next »