« previous next »
Pages: [1]   Go Down

Author Topic: Rochester 2G  (Read 1594 times)

Offline Ethan1

  • Moderator
  • Qjet Hero
  • *****
  • Posts: 1148
Rochester 2G
« on: September 08, 2013, 03:19:52 PM »
 Cliff or anyone,
 I have a '73 C50 Rochester 2G 2-BBL carb. What size bolts do I need for the carb flange (throttle body) to intake? I lost the original bolts. :( I assume the bolts would be 5/16 fine thread (not a 100% sure) and what length? What should I set the idle mixture screws to? 2 turns out? Thanks! :)
Logged
Ethan

1972 Chevelle

(oo______oo)

Offline Ethan1

  • Moderator
  • Qjet Hero
  • *****
  • Posts: 1148
Re: Rochester 2G
« Reply #1 on: September 09, 2013, 08:17:02 PM »
Quote from: Ethan1 on September 08, 2013, 03:19:52 PM
Cliff or anyone,
 I have a '73 C50 Rochester 2G 2-BBL carb. What size bolts do I need for the carb flange (throttle body) to intake? I lost the original bolts. :( I assume the bolts would be 5/16 fine thread (not a 100% sure) and what length? What should I set the idle mixture screws to? 2 turns out? Thanks! :)

 Never mind, found what I needed.
Logged
Ethan

1972 Chevelle

(oo______oo)

Offline joeq

  • Garage guy
  • **
  • Posts: 15
Re: Rochester 2G
« Reply #2 on: September 14, 2013, 08:44:33 PM »
If I remember right, weren't the idle screws set out about twice as much as the QJ? Had trips on a 65 Goat many yrs ago, and think I remember them being about 4-5 turns out.
Logged
Pontiac Enthusiast
Pages: [1]   Go Up
« previous next »