« previous next »
Pages: [1]   Go Down

Author Topic: Setting idle mixture screws - vacuum gauge or tach?  (Read 3081 times)

Offline novadude

  • Carb lover
  • ***
  • Posts: 87
Setting idle mixture screws - vacuum gauge or tach?
« on: November 07, 2013, 06:52:07 AM »
I generally use a tach and look for highest idle speed, turn screws in until idle just starts to drop, than back out 1/2-3/4 turn.  I've heard others say that using a vacuum guage is the best way to go.  What method do you guys generally use?
Logged

Offline Cliff Ruggles

  • Administrator
  • Qjet Hero
  • *****
  • Posts: 5432
Re: Setting idle mixture screws - vacuum gauge or tach?
« Reply #1 on: November 12, 2013, 03:56:48 AM »
I set the screws for highest rpm's, then slowly turn them in until I notice a slightly speed change or change in exhaust note (going lean).  Back them up about 1/3 to 3/4 turns each from that point.  You are setting them right on the edge of "lean tip-in".  This will be the best place to set them for most applications.....Cliff
Logged

Offline Schurkey

  • Carb lover
  • ***
  • Posts: 157
Re: Setting idle mixture screws - vacuum gauge or tach?
« Reply #2 on: November 22, 2013, 09:38:10 PM »
My experience has been that a vacuum gauge is far more sensitive than a tach.

Try both...see which one you like better.
Logged
Demand compensation from Communist China for the damage done by the Virus Originating in the Wuhan Lab, released (intentionally or negligently) into the world in 2019 (VOWL-19).  Trillions of dollars, plus direct compensation to individuals for medical bills, and "wrongful death" settlements.
Pages: [1]   Go Up
« previous next »