« previous next »
Pages: [1]   Go Down

Author Topic: were to buy drill bits for carb work????  (Read 2157 times)

Offline maddogs1965

  • Garage guy
  • **
  • Posts: 7
were to buy drill bits for carb work????
« on: January 04, 2015, 06:57:06 PM »
Hey Cliff!!!

Just received you book on Q jets and all the parts i ordered AWESOME READING!!!!

But i am having one heck of a time trying to find a set of small drill bits to start doing some mods on the Q jet!!!

I am think i need from .025 up to .100, were do you purchase your drill bits from if you don't mind me asking!!!!

Thanks

Rick
Logged

Offline maddogs1965

  • Garage guy
  • **
  • Posts: 7
Re: were to buy drill bits for carb work????
« Reply #1 on: January 04, 2015, 08:51:35 PM »
Well now i am kicking my self in the butt, i was down in Reno today, and Harbor freight has the little drill bits, and i did not even think of them  :(
Logged

Offline Cliff Ruggles

  • Administrator
  • Qjet Hero
  • *****
  • Posts: 5418
Re: were to buy drill bits for carb work????
« Reply #2 on: January 05, 2015, 04:21:31 AM »
Harbor freight is a good source for the 1-60 set.  The 61-80 set is available thru a lot of sources, but I would avoid the cheap imported sets, get one from HUOT.  The imported stuff breaks too easy, and sizing is poor on them.....Cliff
Logged

Offline oktorque

  • Garage guy
  • **
  • Posts: 46
Re: were to buy drill bits for carb work????
« Reply #3 on: January 08, 2015, 08:51:13 AM »
I have found that having a dial caliper is invaluable.  Not only can I measure metering rods when I can no longer read the stamp, but I measure the bits before use as well.  I wouldn't be able to do the work without the dial caliper--and they are inexpensive too.
Logged
Pages: [1]   Go Up
« previous next »