« previous next »
Pages: [1]   Go Down

Author Topic: Secondary well restrictions  (Read 1341 times)

Offline jagness

  • Garage guy
  • **
  • Posts: 18
Secondary well restrictions
« on: November 18, 2020, 09:56:32 AM »
I'm working on a 17080249 that was previously modified by someone else. Most of the mods were done pretty well, but they drilled the secondary well restrictions out to .071-.072 (a #50 bit fits loose, but a #49 won't go in). Has anyone tried to install set screws in this area? I have a lathe and have drilled set screws to repair IABs in other quadrajets, but never the secondary well restrictions. Is there a better way to fix this problem?
Logged

Offline mcx

  • Carb lover
  • ***
  • Posts: 140
Re: Secondary well restrictions
« Reply #1 on: November 18, 2020, 01:35:42 PM »
...I have drilled them out and tapped for 8/32" brass set screws, which I redrilled to .039"
...it worked out fine.
« Last Edit: November 18, 2020, 01:41:39 PM by mcx »
Logged

Offline Cliff Ruggles

  • Administrator
  • Qjet Hero
  • *****
  • Posts: 5418
Re: Secondary well restrictions
« Reply #2 on: November 19, 2020, 03:13:42 AM »
I reduce them to smaller sizes on occasion.  I use a #4-40 brass set screw pre-drilled before I install it......
Logged
Pages: [1]   Go Up
« previous next »