« previous next »
Pages: [1]   Go Down

Author Topic: Idle tube removal  (Read 1238 times)

Offline Corey

  • Garage guy
  • **
  • Posts: 7
Idle tube removal
« on: April 12, 2018, 06:17:57 PM »
The tubes did not punch down without the collars so I tried propane plumbers torch with tip of a drywall screw to grab the tube with no luck, the screw wouldn't grab it.  Do I need to find an ultra tiny screw to thread into the tube?
Logged

Offline Cliff Ruggles

  • Administrator
  • Qjet Hero
  • *****
  • Posts: 5418
Re: Idle tube removal
« Reply #1 on: April 12, 2018, 07:48:10 PM »
Use a .089" drill bit and drill the tubes down about 1/8" or so or just enough to get a good hold in them with a self tapping wood or drywall screw.  With a little heat against the casting they will come right out......Cliff
Logged
Pages: [1]   Go Up
« previous next »