« previous next »
Pages: [1]   Go Down

Author Topic: White power piston retainers, o.d. To big?  (Read 876 times)

Offline Mr.Pontiac

  • Qjet Hero
  • *****
  • Posts: 544
White power piston retainers, o.d. To big?
« on: August 24, 2022, 06:58:36 AM »
7029263 power piston bore, I have 4 from previous kits, all to bid o.d. Will not fit. Anybody else going thru this? Please look into this.
Logged

Offline Cliff Ruggles

  • Administrator
  • Qjet Hero
  • *****
  • Posts: 5401
Re: White power piston retainers, o.d. To big?
« Reply #1 on: August 24, 2022, 07:45:02 AM »
They are "interference" fit so go in with some effort.  Never had any issues getting them in. 

Take a pocket knife and chamfer the lower edge a little more.  On the ones I sell I've already removed the sharp edge and chamfered them a bit, but sometimes they need a little more help.....
Logged

Offline Mr.Pontiac

  • Qjet Hero
  • *****
  • Posts: 544
Re: White power piston retainers, o.d. To big?
« Reply #2 on: August 24, 2022, 09:39:47 AM »
I am micing bore at .380 plastic bushings .392, going to be a real tight fit
Logged

Offline quadrajam

  • Carb lover
  • ***
  • Posts: 101
Re: White power piston retainers, o.d. To big?
« Reply #3 on: August 24, 2022, 05:54:50 PM »
Out of curiosity I went out to the shop and installed one of
Cliffs PP retainers in a 17084226 casting that was laying around.
As usual it's tight but it fits.
There is a step at the top of the bore where the retainer fits
that is 0.392 inch. Check that the stepped area is not occupied
with part of the old retainer.  ...????
Logged
Pages: [1]   Go Up
« previous next »