I own a 1985 Bayliner 2450 CB with a 225AQ Volvo-Penta (305ci) I rebuilt the Q-jet with a marine kit from Cliff's and inhaled a new electronic distributer. First time out ran well at first, however, was low on gas and put in 30 gal. 91 octane at local marina after that could not get it above 1000k rpm's without it wanting to cut out. At home I change out fuel/seperator filter, pulled gas flaot assembly and did my best to look in tank, could not pull pickup tube so blew air down through it. Went out again yesterday, ran up river for 20 minutes and it ran great. Shut her down and was enjoying the river, after a little time started up and then could only get up to 2000k rpm's above that wants to cut out. In neutral, it runs fine at higher rpm's, appears just under load. I did replace the fuel pump(mechanical) this winter. I was wondering if it was carb issues what would I look for?
Thanks