« previous next »
Pages: [1]   Go Down

Author Topic: Mixture screw setting?  (Read 2469 times)

Offline oktorque

  • Garage guy
  • **
  • Posts: 46
Mixture screw setting?
« on: February 13, 2015, 05:08:28 PM »
Where is a good spot to set the mix screws before install if the original setting was lost?
Logged

Offline Ethan1

  • Moderator
  • Qjet Hero
  • *****
  • Posts: 1148
Re: Mixture screw setting?
« Reply #1 on: February 13, 2015, 05:46:26 PM »
Quote from: oktorque on February 13, 2015, 05:08:28 PM
Where is a good spot to set the mix screws before install if the original setting was lost?

 Probably 11/2 to 2 turns out. At least, that is what I usually set them at. Nobody is the same. :D
Logged
Ethan

1972 Chevelle

(oo______oo)

Offline Cliff Ruggles

  • Administrator
  • Qjet Hero
  • *****
  • Posts: 5432
Re: Mixture screw setting?
« Reply #2 on: February 17, 2015, 03:51:06 AM »
Depends on carb number.  Could be anywhere from 1.5 to 5-6 turns....Cliff
Logged

Offline oktorque

  • Garage guy
  • **
  • Posts: 46
Re: Mixture screw setting?
« Reply #3 on: February 25, 2015, 08:59:05 AM »
It is a 17059547.  I have opened up the mix holes to .090.
Logged

Offline Cliff Ruggles

  • Administrator
  • Qjet Hero
  • *****
  • Posts: 5432
Re: Mixture screw setting?
« Reply #4 on: March 06, 2015, 03:39:43 PM »
With mixture screw holes that big about 1.5 to 2.5 turns out from seated for initial testing.....Cliff
Logged
Pages: [1]   Go Up
« previous next »