« previous next »
Pages: [1]   Go Down

Author Topic: replacing bushings  (Read 3393 times)

Offline FORREST MILLER

  • Garage guy
  • **
  • Posts: 16
replacing bushings
« on: October 06, 2008, 12:02:59 PM »
Hi Cliff, I just replaced the primary shaft bushings in my carb, and the clearance between the new bushing and shaft is .004". Is this OK, or should I be looking for a tighter clearance. ( Bushing measures .312", Primary shaft measures .308")

Thanks.....Forrest
Logged

Offline Cliff Ruggles

  • Administrator
  • Qjet Hero
  • *****
  • Posts: 5418
Re: replacing bushings
« Reply #1 on: October 21, 2008, 04:29:23 AM »
Forrest, .004" clearance is fine, they weren't that tight from the factory......Cliff
Logged
Pages: [1]   Go Up
« previous next »