Author Topic: Recipe for Ford 300  (Read 1318 times)

Offline F250 Restorer

  • Carb lover
  • ***
  • Posts: 101
Recipe for Ford 300
« on: September 08, 2020, 10:47:07 AM »
I have a 17059247. It is going on a newly rebuilt Ford 300 (306 ci) in a truck with a manual trans and 3.31 rear gears. The engine is about 250 hp, with just under 9:1 cr, with a fairly large (280 adv., 220 @.050, .480 lift, 112 lsa)cam, 14hg at idle. I was going to use 'Recipe #1' in cliff's book, but wasn't sure due to the engine being a 6 instead of an v8.

I am also curious about whether to drill the primary butterflies to add some bypass air. I am using a baseplate from another 1705 without bypass air. If so, how much? Thanks for the help.

Offline Cliff Ruggles

  • Administrator
  • Qjet Hero
  • *****
  • Posts: 5347
Re: Recipe for Ford 300
« Reply #1 on: September 10, 2020, 04:56:57 AM »
Do NOT swap out the baseplates, always use the original one that came with the carburetor.

Do NOT drill the throttle plates, use the idle bypass air system if/as needed instead.

With that much cam in the little 300 you are going to need some additional idle fuel and some bypass air.  I'd be looking closer to recipe #3 instead of #1.

Make sure to get one of my rebuild kits for the carb. I will include the later design high flow N/S assembly and it comes with a lifetime warranty accl pump with new custom wound springs and pump seal.  You will also get the secondary cam/spring as well.....Cliff