Author Topic: why 2 of these in Cliff's kits?  (Read 1062 times)

Offline stevef

  • Carb lover
  • ***
  • Posts: 81
why 2 of these in Cliff's kits?
« on: September 10, 2022, 12:14:17 PM »
In the kits I've gotten from Cliff, there are 2 of these small black seals/grommets. I realize one is the seal for the choke shaft to carb body hole. What is the other for? Or is it just an extra? Thanks.
« Last Edit: September 10, 2022, 12:18:32 PM by stevef »

Offline 77cruiser

  • Qjet Hero
  • *****
  • Posts: 625
Re: why 2 of these in Cliff's kits?
« Reply #1 on: September 10, 2022, 08:05:11 PM »
The other might go on the accel. pump.
Jim

Offline stevef

  • Carb lover
  • ***
  • Posts: 81
Re: why 2 of these in Cliff's kits?
« Reply #2 on: September 10, 2022, 08:21:43 PM »
Thanks for the thought, but I've never found one of those on the accelerator pumps of the multiple q-jets I've disassembled, so I don't think one goes there.

Thinking further about it, I believe I've figured it out. I believe the 2nd one goes where the choke shaft goes through the choke housing, in case you take the choke completely apart.
« Last Edit: September 10, 2022, 08:32:05 PM by stevef »

Offline Cliff Ruggles

  • Administrator
  • Qjet Hero
  • *****
  • Posts: 5418
Re: why 2 of these in Cliff's kits?
« Reply #3 on: September 12, 2022, 03:19:03 AM »
If your carb has a "hot air" choke the second one seals the choke shaft inside the housing.  You have to take the hot-air choke apart to install it....

Offline stevef

  • Carb lover
  • ***
  • Posts: 81
Re: why 2 of these in Cliff's kits?
« Reply #4 on: September 12, 2022, 09:02:55 AM »
Thanks for the confirmation Cliff.