News:
Buy "The Book" on Q-jets and OverDrive Transmission Swaps. On the Website Home Page!
| Subject / Started by | Replies / Views | Last post  |
||
|---|---|---|---|---|
|
|
Replacing Main Well Bleed Tubes
Started by von |
4 Replies
2536 Views |
June 22, 2010, 04:17:22 AMby Cliff Ruggles |
|
|
|
best way to get in touch
Started by jaros44sr |
5 Replies
2710 Views |
June 14, 2010, 07:03:56 AM by jamesF |
|
|
|
Choke Pull-Off Vacuum Line
Started by Ethan1 |
0 Replies
2470 Views |
June 13, 2010, 10:36:08 AM by Ethan1 |
|
|
|
Rusty vacuum ports
Started by Spudboy |
0 Replies
2223 Views |
June 12, 2010, 12:48:07 PM by Spudboy |
|
|
800 CFM Carbs
Started by rr67gto |
2 Replies
2795 Views |
June 05, 2010, 09:08:22 PM by rr67gto |
|
|
|
Dirt oval track Qjet
Started by 77cruiser |
4 Replies
2733 Views |
June 05, 2010, 06:15:14 AM by 77cruiser |
|
|
|
Choke Pull-Off
Started by SundanceKid |
2 Replies
2683 Views |
May 28, 2010, 02:58:28 AM by SundanceKid |
|
|
|
Edelbrock Secondary Air Flaps
Started by SundanceKid |
3 Replies
2775 Views |
May 28, 2010, 02:38:29 AM by Cliff Ruggles |
|
|
|
Recipes @ altitude
Started by SundanceKid |
2 Replies
2516 Views |
May 27, 2010, 09:19:15 PM by SundanceKid |
|
|
|
Plating and lessons learned
Started by makomark |
5 Replies
8066 Views |
May 27, 2010, 08:58:13 PM by SundanceKid |
|
|
|
Ported vacuum?
Started by Toronado |
3 Replies
3225 Views |
May 27, 2010, 01:36:53 AM by Toronado |
|
|
|
Original jets & rods
Started by 77cruiser |
2 Replies
2506 Views |
May 26, 2010, 11:53:24 AM by 77cruiser |
|
|
|
5 Replies
3410 Views |
May 25, 2010, 06:51:02 AM by thumper |
|
|
|
|
Port letters on Q-Jet housing
Started by johngaltx |
2 Replies
2384 Views |
May 19, 2010, 01:20:53 PM by johngaltx |
|
|
|
just wondering...
Started by Marx3 |
3 Replies
2206 Views |
May 16, 2010, 04:26:28 PM by Toronado |
|
|
|
Carb build sheet
Started by 77cruiser |
5 Replies
3055 Views |
May 14, 2010, 07:47:07 AM by A. G. Olphart |
|
|
18 Replies
6662 Views |
May 13, 2010, 12:09:16 PM by Marx3 |
|
|
|
|
Fuel ratio & float level
Started by 77cruiser |
1 Replies
2144 Views |
May 13, 2010, 05:15:03 AM by Cliff Ruggles |
|
|
|
ULTRASONIC CLEANERS
Started by billy 2 |
1 Replies
2285 Views |
May 09, 2010, 03:58:09 AM by Cliff Ruggles |
|
|
|
Removing Primary Shaft Screws
Started by von |
1 Replies
2048 Views |
May 08, 2010, 05:05:19 AM by billy 2 |
Normal Topic
Hot Topic (More than 10 replies)
Very Hot Topic (More than 20 replies)
Locked Topic
Sticky Topic
Poll