Sealing the Vacuum tree

[gr8whitebuffalo]

Hi all,

I've installed my carb and am doing fine-tuning now.  When I installed my carb I noticed that the vacuum "tree" (the multi-pronged vacuum connection on the back of the carb base that provides a number of manifold vacuum sorces for various accessories, etc) wasn't able to thread in real tight on the carb base, mostly because of the alignment of a hardline hookup.  Bascially I can wiggle the tree a bit in the threads in this position and am afraid that it might be introducing a little bit of a vacuum leak.

What can I use to seal up these threads?

Thanks!
-Trevor

[leeklm]

I would start with a few wraps of white teflon plumbers tape.  After that, you could hit it with a little carb spray while engine is running to determine if it is leaking.

[gr8whitebuffalo]

Thanks!   

[gtome]

Sorry to jack, but speaking of vac trees, is there somewhere you can get them that only have 3-4 ports and not 40?!