« previous next »
Pages: [1]   Go Down

Author Topic: secondary throttle shaft loose  (Read 3014 times)

Offline Matt

  • Newbie
  • *
  • Posts: 2
secondary throttle shaft loose
« on: April 19, 2009, 05:28:59 PM »
can a secondary shaft be bushed to eliminate looseness?
Logged

Offline Schurkey

  • Carb lover
  • ***
  • Posts: 157
Re: secondary throttle shaft loose
« Reply #1 on: April 20, 2009, 10:45:22 AM »
Quote from: Matt on April 19, 2009, 05:28:59 PM
can a secondary shaft be bushed to eliminate looseness?
Mine was.

The guy (NOT Cliff!) didn't do a very good job, but the process is valid.
Logged
Demand compensation from Communist China for the damage done by the Virus Originating in the Wuhan Lab, released (intentionally or negligently) into the world in 2019 (VOWL-19).  Trillions of dollars, plus direct compensation to individuals for medical bills, and "wrongful death" settlements.

Offline Cliff Ruggles

  • Administrator
  • Qjet Hero
  • *****
  • Posts: 5418
Re: secondary throttle shaft loose
« Reply #2 on: April 26, 2009, 04:09:06 AM »
They are supposed to have some play to allow the throttle plates to self-center when the close.

I've seen a few carbs come in here that had bushings installed for the secondary shaft, a few of them were off just enough so that the throttle plates allowed too much air into the engine at idle as the they were not seating evenly on both sides. 

I would not recomend installing bushings for the secondary throttle shaft for this reason.  The throttle plates are made so that they seal very tightly in the bores. 

We have seen quite a few bent/twisted shafts, which must be replaced or straightened so the throttle plates seal effectively on both sides.....Cliff
Logged
Pages: [1]   Go Up
« previous next »