Quadrajet Problem Solving > Dialing in your rebuilt Quadrajet carburetor
Qjet building
FORREST MILLER:
I stand corrected.......Thanks to JeffWalker I was able to find the correct holes for the squirters and measured the best I could ( I'm missing a few drill bits) and determined its about .026"
FORREST MILLER:
So Cliff,
How about my carb ( 17080207), with the main airbleeds reduced to .070", setup to Recipe 2,with my engine combo......will that work OK?
Thanks, Forrest Miller
Cliff Ruggles:
Recipe #2 should be really close. We have custom screw in airbleeds and a jet/rod package for those carburetors, takes the hassle out of trying to reduce the airbleed diameters and coming up with the best jet/rod combinations........Cliff
comp:
--- Quote from: Cliff Ruggles on September 18, 2008, 04:49:54 AM ---Recipe #2 should be really close. We have custom screw in airbleeds and a jet/rod package for those carburetors, takes the hassle out of trying to reduce the airbleed diameters and coming up with the best jet/rod combinations........Cliff
--- End quote ---
are these parts in your book ?
Cliff Ruggles:
No, we sell them separately from our kits. We did not put ourselves down as a parts supplier in the book. The demand has been great enough since the book came out that we have stepped up and had a lot of parts manufactured, and started putting custom rebuild kits together, etc......Cliff
Navigation
[0] Message Index
[#] Next page
[*] Previous page
Go to full version