Quadrajet Problem Solving > Dialing in your rebuilt Quadrajet carburetor

Primary metering rod arm

<< < (2/2)

Ozzmann:
Sorry guys, it's a 17057262, not 1262. Cliff I had to bend the T arm in order to set rods deep enough into jets.
With arm's level and power  piston pushed down as far as it will go, the power tips were just inside the jets at idle.

Ethan1:

--- Quote from: Ozzmann on May 16, 2013, 03:50:12 PM ---Sorry guys, it's a 17057262, not 1262. Cliff I had to bend the T arm in order to set rods deep enough into jets.
With arm's level and power  piston pushed down as far as it will go, the power tips were just inside the jets at idle.

--- End quote ---

 Stock internals were .071 Primary Jets, 43L Primary Metering Rods, K Secondary Hanger, and DB Secondary Metering Rods. :D

Cliff Ruggles:
Check to make sure the power piston hanger is fully seated in the body.  You should not have to bend the hanger arms down for that application....Cliff

Navigation

[0] Message Index

[*] Previous page