« previous next »
Pages: [1]   Go Down

Author Topic: Choke Pull Off Vacuum Amount  (Read 2007 times)

Offline firebird_fast

  • Garage guy
  • **
  • Posts: 7
Choke Pull Off Vacuum Amount
« on: July 15, 2013, 12:37:29 PM »
Hi, what is the correct amount of vauum I should see when I test the choke pull off?  Thanks.
Logged

Offline Shark Racer

  • Jet Head
  • ****
  • Posts: 288
Re: Choke Pull Off Vacuum Amount
« Reply #1 on: July 15, 2013, 06:23:41 PM »
Pump it up until the arm is completely retracted. At that point, it should hold vacuum.
Logged

Offline firebird_fast

  • Garage guy
  • **
  • Posts: 7
Re: Choke Pull Off Vacuum Amount
« Reply #2 on: July 16, 2013, 06:23:49 AM »
I'll give it a shot, thanks.
Logged

Offline Ethan1

  • Moderator
  • Qjet Hero
  • *****
  • Posts: 1148
Re: Choke Pull Off Vacuum Amount
« Reply #3 on: July 16, 2013, 04:05:28 PM »
Quote from: Shark Racer on July 15, 2013, 06:23:41 PM
Pump it up until the arm is completely retracted. At that point, it should hold vacuum.

 I agree with, Steve. At least, that is the way I check them.
Logged
Ethan

1972 Chevelle

(oo______oo)

Offline Cliff Ruggles

  • Administrator
  • Qjet Hero
  • *****
  • Posts: 5418
Re: Choke Pull Off Vacuum Amount
« Reply #4 on: July 22, 2013, 05:09:47 AM »
Just compress the unit and hold your finger over the supply.  If it doesn't hold it's not any good.  They used a lot of different pull-offs, which require different amounts of vacuum to fully apply them. 

Some later units have a "bleed-off" hole in them, so they will always fail a vacuum test. Make sure to hold a finger over that hole as well when testing them.....Cliff
Logged
Pages: [1]   Go Up
« previous next »