Quadrajet Problem Solving > Diagnose a Quadrajet carburetor problem
extra piece after rebuilding quadrajet
shanes77ta:
hey guys, i am curious if any of you have seen where this piece that i have after rebuilding my quadrajet goes or came from... I have a solid green pin that i cannot figure out where it goes. it is approximately 3/16 inches in diameter and 3/4 inches long..
shanes77ta:
also, it came out of a 1983 caprice wagon and the casting number is 17084208.
shanes77ta:
here is a picture
Ethan1:
--- Quote from: shanes77ta on September 13, 2013, 06:50:52 PM ---here is a picture
--- End quote ---
Welcome to CHP!
That piece looks to be the pushrod for the throttle position sensor and acts as a plunger. If you turn the air horn upside down, you will see the lever for the TPS and a hole right beside it. That is where it goes.
shanes77ta:
sorry for this response as it is very novice but this was the first carb i have opened up/rebuilt. i have always had someone else help with the carb stuff so... what is the air horn? also i always say im from missouri, show me... im not up on my terminology yet.
thank you for the help!
Navigation
[0] Message Index
[#] Next page
Go to full version