« previous next »
Pages: [1]   Go Down

Author Topic: 17056230 Rebuild Questions  (Read 3550 times)

Offline ag_eet

  • Newbie
  • *
  • Posts: 4
17056230 Rebuild Questions
« on: October 11, 2013, 12:45:52 PM »
I have two 17056230 cores I plan to rebuild into one for my 1975 Chevrolet 350.  One of the air horns is in better condition except it is missing the plug in the hole next to the accelerator plunger (not the APT hole).  The metal is pretty thin there but I was considering threading and plugging it with a set screw similar to what is done for the APT hole.

Also I noticed in cliff's quadrajet book on page 88 the high performance carburetor picture looks to have epoxy in the well near the screw.  Is that a good method because I'd like to also use epoxy instead of the little gasket from a kit.

Thanks for any comments/suggestions.
Logged

Offline ag_eet

  • Newbie
  • *
  • Posts: 4
Re: 17056230 Rebuild Questions
« Reply #1 on: October 15, 2013, 06:49:51 PM »
crickets..... :)
Logged

Offline Cliff Ruggles

  • Administrator
  • Qjet Hero
  • *****
  • Posts: 5418
Re: 17056230 Rebuild Questions
« Reply #2 on: October 31, 2013, 03:53:21 AM »
Can you post a pic of what you are talking about?....Cliff
Logged

Offline ag_eet

  • Newbie
  • *
  • Posts: 4
Re: 17056230 Rebuild Questions
« Reply #3 on: October 31, 2013, 07:09:47 PM »
Thanks for the response Cliff.  See the hole next to the accelerator pump?
Logged

Offline ag_eet

  • Newbie
  • *
  • Posts: 4
Re: 17056230 Rebuild Questions
« Reply #4 on: October 31, 2013, 07:27:59 PM »
Cliff, Is that epoxy around the front middle screw?
Logged

Offline Cliff Ruggles

  • Administrator
  • Qjet Hero
  • *****
  • Posts: 5418
Re: 17056230 Rebuild Questions
« Reply #5 on: November 05, 2013, 03:40:00 AM »
That hole would need to be plugged to keep fuel from spilling out when in use.

Can't see the second pic well enough to know about epoxy around the front screw?....Cliff
Logged
Pages: [1]   Go Up
« previous next »