General Category > Quadrajet Carb Talk and Tips

Which carb to use?

<< < (3/3)

Schurkey:
My problem has been with the quality of pin vices, as I've already got sets of quality number drills.

The "General" #92 pin vice I bought holds the drills so far off-center as to be very frightening.  They won't answer my e-mails about it, either.  The collets look like they were cut by a blind man.  Thanks for reminding me, its time to jack them up again...

http://www.generaltools.com/Products/Swivel-Head-Pin-Vise__92.aspx

Bought another brand of pin vice, but haven't unwrapped it yet...

Mark R:
The pin vise I bought only has one collet I need to get one to fit the smaller bits 61-80.   

omaha:
I got lucky and found an old pin vice at a swap meet. It has 2 different size collets and is of extremley good quality. The guy was like "what are you gonna use that for" , "I build carbs" I said. He says " most people dont even know what that is, I'm just gonna give it to you"  Its neat, it has a knob on top that spins the bit seperate from the body.   

Navigation

[0] Message Index

[*] Previous page