Quadrajet Problem Solving > Diagnose a Quadrajet carburetor problem

Vacuum leak at idle, hard start

(1/2) > >>

W30Olds:
Would incorrectly indexed secondary plates cause a vacuum leak at idle? make the engine hard to start? I rebuilt the carb and used bronze bushings but I believe I might not have indexed the secondary plates correctly, everything else looked fine.

ejowrench:
Perhaps. Place a wet rag around the secondary air valve, sealing it. If the idle does not change, look some where else....

What makes you think you have a vacuum leak?

W30Olds:
Its off the car now, apart. I placed a rag over the primaries when it was running and didnt do anything, then placed a rag over it with both hands sealing it and just barely changed the idle.  The engine made 18 inches of vacuum at idle warmed up, but started kind off hard. The engine was shaking and you could hear it through the exhaust, sounded like a miss or vacuum leak.

I put a reman qjet on it and it definitely idles better than the rebuilt original.

Cliff Ruggles:
What method did you use to install the bushings?......Cliff

W30Olds:
Your kit, per instructions.  Should the secondary plates show any light through them closed?

Navigation

[0] Message Index

[#] Next page