« previous next »
Pages: [1]   Go Down

Author Topic: Cliff, white plastic power piston seal question  (Read 2627 times)

Offline Mr.Pontiac

  • Qjet Hero
  • *****
  • Posts: 544
Cliff, white plastic power piston seal question
« on: October 13, 2009, 08:13:22 AM »
I bought a few from you some time ago, am i correct in thinking these need a split cut into them to put them on? Only way i know of putting them on unless you take top of power piston arm off. Thank You
Any input would be helpfull
Logged

Offline Mr.Pontiac

  • Qjet Hero
  • *****
  • Posts: 544
Re: Cliff, white plastic power piston seal question
« Reply #1 on: October 13, 2009, 08:15:56 AM »
Also how do you recommend this split if needed to be done?? how wide??
Logged

Offline Cliff Ruggles

  • Administrator
  • Qjet Hero
  • *****
  • Posts: 5435
Re: Cliff, white plastic power piston seal question
« Reply #2 on: October 18, 2009, 07:01:51 AM »
The only ones we sell are already split and slide over the arm after removing the stock one....Cliff
Logged
Pages: [1]   Go Up
« previous next »