« previous next »
Pages: [1]   Go Down

Author Topic: I'm guessing these fittings are not supposed to do this?  (Read 1679 times)

Offline fumehappy

  • Newbie
  • *
  • Posts: 2
I'm guessing these fittings are not supposed to do this?
« on: November 05, 2016, 05:37:28 PM »
So, Pulled my air cleaner to get the casting number to order a rebuild kit from Cliff's, and noticed that the brass fitting that is maybe my vacuum advance was just laying on the intake.   When I went to correct it, the vent hose/ canister hose on top simply slid out.  I fit both back in firmly, but unsure what that happened?

Thanks!





Logged

Offline Jeffs68

  • Carb lover
  • ***
  • Posts: 80
Re: I'm guessing these fittings are not supposed to do this?
« Reply #1 on: November 05, 2016, 09:53:13 PM »
Those vacuum fittings do pop out once in a while, after you rebuild it and clean things up, you can take a center punch and stake them if you want.
Logged
-Jeff

Offline 77cruiser

  • Qjet Hero
  • *****
  • Posts: 625
Re: I'm guessing these fittings are not supposed to do this?
« Reply #2 on: November 06, 2016, 05:15:49 AM »
Once cleaned up you can use some Locktite I use red or green. That keeps them in place.
Logged
Jim
Pages: [1]   Go Up
« previous next »