Hello
I have a 19083522 on a mercruiser I have been struggling with for a couple of years now. It runs like a raped ape when over 1000 rpm with float level at 3/8 per the Merc manual, 1/4 gets a lot of dripping from the stern primary. I have replaced kit cheap rebuild kit with a cliff kit, but have the same issue I originally had. I have 5.5 fuel pressure when cranking, have replaced the fuel pump, vacuum checked the needle and seat as well as pressure checked with no leak until 7 psi. I only have the idle screws out to 2 turns and adjusted to where the engine is at max rpm plus 1/2 turn. The boat does sit stern low in the water as I added a swim platform. I can make a wedge up from a spacer I have, but am trying to avoid it. I have read that running lean can cause primary drip. What should I be trying to do here as this is getting painful when trolling? Thanks in advance for your replies
