« previous next »
Pages: [1]   Go Down

Author Topic: 7045213 project  (Read 1244 times)

Offline Sonny

  • Carb lover
  • ***
  • Posts: 53
7045213 project
« on: January 29, 2019, 09:41:50 AM »
Picked up a new project carb recently. Codes are 7045213, YA, date 0095.

It appears to have been freshly rebuilt before it was hidden in a box on a shelf my father's shop.

I don't think it has the factory configuration, though. Can I get a sanity check on the measurements, please?
  • Metering Rods: primary 46 (not marked B, so assume they're A); secondary DA
  • Main jets: 71
  • Idle circuit: upper air bleeds .0935, lower air bleeds .0635, idle tube jet .039, DCR .063, bypass air .096
  • Mixture screw holes: .089
  • Accelerator pump discharge holes: .026
  • Main circuit: upper air bleeds  .0465, lower air bleeds .0465
  • The APT is in the base plate and it is exposed.
Logged

Offline Cliff Ruggles

  • Administrator
  • Qjet Hero
  • *****
  • Posts: 5432
Re: 7045213 project
« Reply #1 on: January 30, 2019, 02:30:10 AM »
Most likely its been commercially "remanufactured" not "rebuilt".  Those sizes are not correct for that carb number as far as main airbleeds, jets and metering rods.......Cliff
Logged

Offline Sonny

  • Carb lover
  • ***
  • Posts: 53
Re: 7045213 project
« Reply #2 on: January 30, 2019, 04:57:55 AM »
Thank you Cliff. This may be one of those lessons in humility you have written about here on the forum. I will give it a closer inspection to see if it has any of the other changes common to remanufactured units.
Logged
Pages: [1]   Go Up
« previous next »