Quadrajet Problem Solving > Dialing in your rebuilt Quadrajet carburetor
6 cyl draw threw turbo
hiy_po:
800 CFM cast main body ??
tayto:
have you tried going to a local machine shop and seeing if they have or can get the hardware you need? I would do this before looking online personally.
hiy_po:
I dont live near a city, I live rural WA about 4 hours out of Perth. Its an hour away to nearest machine shop and they can supply grub screws but not in Brass.
I can not get Brass 6-32, 8-32 or 10-32 cup point set screws locally or online.
Only way I can get them is if Cliff wants to sell me some or someone wants to send me some, I will quite happily pay for a bag of 50 of each.
I may be needing a new set of Gaskets as mine are looking very used so maybe if I order some gaskets can order some screws as well.
hiy_po:
I need the next step in setting up this idle circuit as its Idling very rough and have no control at all with Idle mixture screws. Seems to be running richer as well. I do notice when secondaries kick in it pulls harder. But need some idle control back please. My guess is smaller bleeds are pulling more threw the big IDCR and Idle tubes. But will wait to hear it and what sizes are recommended.
77cruiser:
Her ya go everything you need.
https://www.mcmaster.com/brass-set-screws
Navigation
[0] Message Index
[#] Next page
[*] Previous page
Go to full version