Quadrajet Problem Solving > Dialing in your rebuilt Quadrajet carburetor

6 cyl draw threw turbo

<< < (4/9) > >>

hiy_po:
Cancelling Your McMaster-Carr Order on 10/06
Contact photo
From   McMaster-CarrAdd contact
To   hiy_po@hiy-po.comAdd contact
Date   2019-10-07 21:26
Message Body
Hi Adam,

 

Thank you for considering McMaster-Carr for your purchase.  However, we will not accept orders from your location due to the cost of complying with US export regulations.

 

Andrew

 

77cruiser:
That's a bummer.  If all you need is some set screws, I'll see what I have & could send you some in the mail.

hiy_po:
I dont know if I can do it, but if possible I would buy some and send to your address or any US address and get you to forward to me. I would just need to know postage costs and if you want a fee just add it on and can send you a payment by what ever method works. 
This car is my daily driver and am out in the bush so I do need to get it going again asap.  It is really running to rich now to drive.
 If you do have half a doz 6-32 and maybe 4x 8-32 you have spare and could stick them in an envelope and send me I am at
Adam Hill
19 Monger street
Bencubbin WA
Australia 6477

It is absurd That I have been chasing these things for over a month and cant get them.
I have used the mounts from an old computer mother board (see pic) to do the LIAB, and made my MAB adjustable as well. but am out of them nowl. The original MAB look to be the same as the IDCR's so have soldered the bottom and drilled to 0.040. Just waiting on Cliff to give me a size to Take them to and I can get this thing at least good enough to drive.

hiy_po:
Cliff
       is there any chance I could get a spec sheet or a link to what the small cubic inch motor Quadrajets were setup like. I have searched but with the exception of a couple articles that dont go into detail I cant find any thing. It would ne extremely helpful to know what these factory carbs were set to. With my low compression I dont expect they will work perfect in mine but it would be great to have a base.
 I need to order a gasket set and some grub screws to.
 And what size should I have my IDCRs drilled to?
                                                                           Thanks.

77cruiser:
I'll see what I have, I should have at least that many. We'll give it a try.

Navigation

[0] Message Index

[#] Next page

[*] Previous page