Quadrajet Problem Solving > Diagnose a Quadrajet carburetor problem

17057274 accelerator pump question

<< < (2/2)

Bills64:
No carb spacer

Bills64:
'64 gto

Cliff Ruggles:
Make sure that when the pull-off is applied all slack is removed so between the link and the secondaries so they are held tightly closed.

No mention of any intake mods but the divider needs to be intact.

If you are running any type of open spacer under the carb try a four hole to isolate one side of the intake from the other. 

The air cleaner lid needs to be at least 3" from the top of the carb to air cleaner gasket surface.

If all those things check out and don't help try raising the secondary metering rods slightly if you are still using the stock hanger.....

Navigation

[0] Message Index

[*] Previous page