Author Topic: 17057231 specs?  (Read 1053 times)

Offline Cadman-iac

  • Carb lover
  • ***
  • Posts: 77
Re: 17057231 specs?
« Reply #15 on: February 03, 2025, 08:37:41 AM »
 Just realized I asked about the wrong carb number. I meant to ask if the 17057231 a good one to use on a 350 SBC?
 Thanks for your help.

Offline Cliff Ruggles

  • Administrator
  • Qjet Hero
  • *****
  • Posts: 5476
Re: 17057231 specs?
« Reply #16 on: February 04, 2025, 05:37:19 AM »
Primary POE is just that.  It ADDS fuel with quick throttle movements and when pressure differential is greater above and below the primary throttle plates. 

It wasn't used on 99 percent of the Q-jets produced and they work fine without it.  I see no need to use it for anything more than it was meant for, really lean set-ups trying to squeak thru the EPA's ever tightening emission standards.

Since most of or all of the emission devices on these engines have been removed or disabled, and most also have engine changes, there is really no reason to use it or any advantages doing so.

Your Caddy carb is a nice unit, but as with any other carb selected it must be set up exactly for the application.  Out of the box it may show a slight advantage to other carbs from that period as the big Caddy engines weren't as efficient as other designs and it delivers more fuel just about everywhere in stock form.........

Offline Cadman-iac

  • Carb lover
  • ***
  • Posts: 77
Re: 17057231 specs?
« Reply #17 on: February 04, 2025, 01:21:38 PM »
  Thanks Cliff,

 I guess I am in need of a kit for it then. Can I order it directly from your website or should I call and speak with you about this?

 Rick

Offline Cadman-iac

  • Carb lover
  • ***
  • Posts: 77
Re: 17057231 specs?
« Reply #18 on: February 05, 2025, 08:29:38 PM »
  Ok, from the factory service manual I found out what the difference is between the 17057230 and the 17057231.
  The 17057230 fits all federal emission rear wheel drive Cadillacs for 1977, and the 17057231 fits the 1977 Eldorado with federal emissions. I guess the Eldorado warranted the POE system for whatever reason.

 Cliff, I need a kit for one of these, I guess it would be the same for either one, but can I order it through the website or should I contact you directly? Please advise.

 Rick

Offline Cadman-iac

  • Carb lover
  • ***
  • Posts: 77
Re: 17057231 specs?
« Reply #19 on: February 06, 2025, 08:47:43 PM »
 Spoke with Cliff today and ordered a kit and a set of rods for the 17057230 carb. Looking forward to getting the parts and setting up this one.
  Thanks Cliff for your help, I appreciate it.