« previous next »
Pages: [1]   Go Down

Author Topic: Removing Loctited Screws  (Read 2135 times)

Offline von

  • Carb lover
  • ***
  • Posts: 177
Removing Loctited Screws
« on: March 27, 2011, 01:20:01 AM »
  Is the proper way to remove Loctited shaft screws by using heat to melt the Loctite? A small butane torch good enough? Much danger of warping the shaft or throttle plates?
Logged

Offline Cliff Ruggles

  • Administrator
  • Qjet Hero
  • *****
  • Posts: 5418
Re: Removing Loctited Screws
« Reply #1 on: March 27, 2011, 04:41:56 AM »
If loctite was used to install them, heat the shaft at each screw with a propane torch for about 15 seconds, they will come right out.....Cliff
Logged

Offline von

  • Carb lover
  • ***
  • Posts: 177
Re: Removing Loctited Screws
« Reply #2 on: March 27, 2011, 05:27:57 AM »
OK. Thanks.
Logged
Pages: [1]   Go Up
« previous next »