Cliff's Quadrajet Parts and Rebuild Kits
Welcome,
Guest
. Please
login
or
register
.
1 Hour
1 Day
1 Week
1 Month
Forever
Login with username, password and session length
News:
I did some SPAMMER cleanup - Report any Posts using the REPORT POST icon.
Home
Help
Search
Login
Register
Cliff's Quadrajet Parts and Rebuild Kits
»
General Category
»
Quadrajet Carb Talk and Tips
(Moderators:
Cliff Ruggles
,
Ethan1
) »
Removing Loctited Screws
« previous
next »
Print
Pages: [
1
]
Go Down
Author
Topic: Removing Loctited Screws (Read 2193 times)
von
Carb lover
Posts: 178
Removing Loctited Screws
«
on:
March 27, 2011, 01:20:01 AM »
Is the proper way to remove Loctited shaft screws by using heat to melt the Loctite? A small butane torch good enough? Much danger of warping the shaft or throttle plates?
Logged
Cliff Ruggles
Administrator
Qjet Hero
Posts: 5435
Re: Removing Loctited Screws
«
Reply #1 on:
March 27, 2011, 04:41:56 AM »
If loctite was used to install them, heat the shaft at each screw with a propane torch for about 15 seconds, they will come right out.....Cliff
Logged
von
Carb lover
Posts: 178
Re: Removing Loctited Screws
«
Reply #2 on:
March 27, 2011, 05:27:57 AM »
OK. Thanks.
Logged
Print
Pages: [
1
]
Go Up
« previous
next »
Cliff's Quadrajet Parts and Rebuild Kits
»
General Category
»
Quadrajet Carb Talk and Tips
(Moderators:
Cliff Ruggles
,
Ethan1
) »
Removing Loctited Screws