Quadrajet Problem Solving > Buy Quadrajet Parts, Quadrajet Kits, Service
Buying Parts and Kits
comp:
that carb looks rough here
jhughes76:
--- Quote from: comp on September 22, 2008, 02:49:26 PM ---that carb looks rough here
--- End quote ---
Up close, it is actually a decent core, if it is not pieced together as I now fear. The seller only halfway cleaned some pretty heavy grease off, so it looks splotchy in the picture. I am gonna try and take a better pic of the linkage/pull-off tomorrow.
jhughes76:
--- Quote from: jhughes76 on September 22, 2008, 10:20:18 AM ---Here is a pic of the side that the seller used on eBay. I will try and get a better pic that zooms-in just on the choke/air flap assemblies. Most of the pics I see in your book, and on google image searches, show the tab on the air flap as slotted on later model carbs with a front pull-off. This carb just has a circle hole in the tab on the air flap connector, like I see on pics of early carbs and rear pull-off carbs, so I am wondering if someone has mixed and matched parts on this one.
--- End quote ---
Here is a better picture of the side that I took.
comp:
--- Quote from: jhughes76 on September 24, 2008, 09:55:24 AM ---Here is a better picture of the side that I took.
--- End quote ---
that is a better pic,,,is the blueing from heat ??
Cliff Ruggles:
That model does not use a link from the primary pull-off to the secondary airflap. It uses a secondary pull-off with two links, one to unload the choke, and one to the airflap linkage.
I have the links in spare parts, used, removed from cores. We always convert them to front pull-off by replacing the secondary airflap shaft and installing a stop for the airflaps.....Cliff
PS: the carb has the wrong fuel filter housing installed on it...
Navigation
[0] Message Index
[#] Next page
[*] Previous page
Go to full version