« previous next »
Pages: [1]   Go Down

Author Topic: Checking base gaskets  (Read 2121 times)

Offline 73 Z28

  • Carb lover
  • ***
  • Posts: 73
Checking base gaskets
« on: December 23, 2011, 02:54:43 PM »
Recently ran into a problem where a carb throttle blades were sticking open after an accel. This ended up being resolved by trimming the base gasket back as it was causing a binding condition with the throttle plates. Wanted to pass this along as one more thing to check before installing any carb back on the intake.
Logged

Offline jamesF

  • Global Moderator
  • Carb lover
  • *****
  • Posts: 171
Re: Checking base gaskets
« Reply #1 on: December 30, 2011, 06:40:50 PM »
That's a very good tip.
Logged

Offline Ethan1

  • Moderator
  • Qjet Hero
  • *****
  • Posts: 1148
Re: Checking base gaskets
« Reply #2 on: December 31, 2011, 06:30:07 PM »
 Thank you. That is a good tip. Probably have to check the base gasket on my engine.
Logged
Ethan

1972 Chevelle

(oo______oo)

Offline Schurkey

  • Carb lover
  • ***
  • Posts: 157
Re: Checking base gaskets
« Reply #3 on: January 04, 2012, 11:19:47 PM »
I've never seen that from the base gasket, but I've seen it several times from a distorted/hardened/ancient throttle body-to main casting gasket.
Logged
Demand compensation from Communist China for the damage done by the Virus Originating in the Wuhan Lab, released (intentionally or negligently) into the world in 2019 (VOWL-19).  Trillions of dollars, plus direct compensation to individuals for medical bills, and "wrongful death" settlements.
Pages: [1]   Go Up
« previous next »