« previous next »
Pages: [1]   Go Down

Author Topic: APT Screw????  (Read 9577 times)

Offline ponchobro

  • Garage guy
  • **
  • Posts: 12
APT Screw????
« on: February 28, 2009, 11:13:40 AM »
Cliff,
I got ahead of myself doing the 17059253 Q-jet for the old 455 and did not count the turns on the APT before I removed it!!! Could you tell me where to set it for a good starting point????

Thanks for your help!!!!
Ken
Logged

Offline Schurkey

  • Carb lover
  • ***
  • Posts: 157
Re: APT Screw????
« Reply #1 on: February 28, 2009, 09:06:44 PM »
I'm thinking The Book suggested 2 turns from seated as a starting point.
Logged
Demand compensation from Communist China for the damage done by the Virus Originating in the Wuhan Lab, released (intentionally or negligently) into the world in 2019 (VOWL-19).  Trillions of dollars, plus direct compensation to individuals for medical bills, and "wrongful death" settlements.

Offline basiccamaro

  • Newbie
  • *
  • Posts: 1
Re: APT Screw????
« Reply #2 on: May 20, 2009, 11:07:26 PM »
I did the same thing, I just got the book shipped to me today but had removed the APT adjustment screw already without noting the setting.  I have only had enough time to quickly scan the book so far.  Do you recall what page or chapter it is that mentions this?  I need to get the carb back together quickly and get the truck back in service.
I had a guy tell me three turns out on the adjustment, but I'm still trying to do some better research. 

Thanks


B.K.
Logged

Offline Cliff Ruggles

  • Administrator
  • Qjet Hero
  • *****
  • Posts: 5432
Re: APT Screw????
« Reply #3 on: May 24, 2009, 05:04:30 AM »
We recomend apprx 3.5 turns up from seated as a base setting.  Use the "tip-in" procedure from the book for fine tuning.

The only time the exact factory setting applies, is when the carburetor is going back on the original application with all of the emission control devices in place and operational, and the engine is stone stock.....Cliff
Logged

Offline Mr.Pontiac

  • Qjet Hero
  • *****
  • Posts: 544
Re: APT Screw????
« Reply #4 on: October 14, 2009, 03:51:32 PM »
Saw the area in the book skipped right by it, sorry guys, thanks for the help!!
Logged
Pages: [1]   Go Up
« previous next »