« previous next »
Pages: [1]   Go Down

Author Topic: Custom rods  (Read 2846 times)

Offline 17058263

  • Garage guy
  • **
  • Posts: 36
Custom rods
« on: March 18, 2012, 02:10:39 AM »
Cliff on your custom rods I have them is the entire uper part .044 to wear it tapers down  ned to know so I can adjext them right heigjt
Logged

Offline Cliff Ruggles

  • Administrator
  • Qjet Hero
  • *****
  • Posts: 5432
Re: Custom rods
« Reply #1 on: March 20, 2012, 04:17:46 AM »
They taper on the upper section apprx .002", then taper all the way down to the .026" tips.  With the rods exactly even, they provide full control from rich to lean on the later carburetors.....Cliff
Logged

Offline F250 Restorer

  • Carb lover
  • ***
  • Posts: 101
Re: Custom rods
« Reply #2 on: March 20, 2012, 11:09:50 AM »
I adjusted the mix in until it stumbles, then out about 1/2 turn.

If it needs more bypass air, and the bypass is plugged, where do I go from here? Should I now remove the restrictions?

Logged

Offline Cliff Ruggles

  • Administrator
  • Qjet Hero
  • *****
  • Posts: 5432
Re: Custom rods
« Reply #3 on: March 21, 2012, 04:10:18 AM »
It should not be dribbling from the main boosters at idle.  Do you have control of the idle speed with the bypass air holes blocked off?.....Cliff
Logged
Pages: [1]   Go Up
« previous next »