General Category > Quadrajet Carb Talk and Tips

Base Gasket

<< < (2/3) > >>

Paul:
What does that U channel do? is there vacume or fuel there? Thanks Cliff

 Paul

Cliff Ruggles:
On most units it leads to two small ports high above the throttle plates, providing a "weak" ported vacuum signal to one of the front fittings, usually used for EGR, etc.....Cliff

Paul:
Cliff,

 Do you have a part number, make ect, so when I call I can give it to who answers? is there anything else needed to make this gasket seal, or will this gasket seal everything without addition of sealer or anything else? Thanks,

Paul

Cliff Ruggles:
Paul, we stock every currently available gasket for the Q-jet to the intake.  Just tell us the carb number, which intake you are going to use, and we will make a recomendation.  If clearance or carb height is a concern, we have gaskets from apprx .080" thick to .250" that will fit your combination of parts.......Cliff

Paul:
This is all going into a 77 Pontiac Trans-Am. Theres the shaker scoop but that shouldnt be an issue. Sealing whatever it needs to seal is this issue.

Navigation

[0] Message Index

[#] Next page

[*] Previous page