« previous next »
Pages: [1]   Go Down

Author Topic: Bent my primary metering rod arm  (Read 2094 times)

Offline Dark T/A

  • Garage guy
  • **
  • Posts: 11
Bent my primary metering rod arm
« on: October 14, 2012, 05:22:03 PM »
in the process of tearing down my carb and following Cliff's book. I tried to be as careful as i could but manage to pry too much and one side of the piston and is now tweaked. What do I do replace it or bend it back??

Logged
-Rick
79 Trans Am 400 4-Speed
Carb#17059263

Offline Shark Racer

  • Jet Head
  • ****
  • Posts: 288
Re: Bent my primary metering rod arm
« Reply #1 on: October 14, 2012, 08:31:13 PM »
Bend it back, just take some measurements to make sure the eyelet of each arm is roughly the same distance to the bowl or other reference points.
Logged

Offline Dark T/A

  • Garage guy
  • **
  • Posts: 11
Re: Bent my primary metering rod arm
« Reply #2 on: October 15, 2012, 07:56:58 AM »
thanks its not too bad shouldnt take much
Logged
-Rick
79 Trans Am 400 4-Speed
Carb#17059263
Pages: [1]   Go Up
« previous next »