Subject / Started by | Replies / Views | Last post | ||
---|---|---|---|---|
Rusty vacuum ports
Started by Spudboy |
0 Replies
2225 Views |
June 12, 2010, 12:48:07 PM by Spudboy |
||
Removing the q-jet choke housing.
Started by Spudboy |
1 Replies
1559 Views |
December 25, 2015, 03:45:54 AM by Cliff Ruggles |
||
Broken tab on air horn.
Started by Spudboy |
1 Replies
2647 Views |
April 11, 2017, 01:58:58 AM by Cliff Ruggles |
||
Can the Qjet be used as a blow through carb?
Started by SRB |
6 Replies
7467 Views |
February 15, 2010, 09:16:57 AM by 77cruiser |
||
7029241 Buick carb
Started by srb12 |
13 Replies
1722 Views |
October 30, 2022, 02:27:25 AM by Cliff Ruggles |
||
using the new idle mixture screws
Started by stevef |
2 Replies
890 Views |
October 25, 2022, 07:43:51 PM by stevef |
||
why 2 of these in Cliff's kits?
Started by stevef |
4 Replies
1049 Views |
September 12, 2022, 09:02:55 AM by stevef |
||
Using the green power piston spring
Started by stevef |
0 Replies
820 Views |
October 16, 2022, 04:59:39 PM by stevef |
||
screw in the bottom of pump well?
Started by stevef |
1 Replies
1411 Views |
April 26, 2014, 02:58:53 PM by stevef |
||
torque converters interchange
Started by stevef |
2 Replies
1129 Views |
June 19, 2022, 01:18:18 AM by stevef |
||
5 Replies
1133 Views |
August 19, 2022, 12:39:07 PM by stevef |
|||
Pulling idle tubes
Started by stevef |
6 Replies
2307 Views |
April 30, 2014, 08:48:41 PM by qjetsrule |
||
th350 question
Started by stevef |
11 Replies
2113 Views |
September 16, 2018, 09:49:09 AM by stevef |
||
th350 lost 3rd gear
Started by stevef |
2 Replies
910 Views |
June 12, 2022, 02:28:57 PM by stevef |
||
3 Replies
912 Views |
September 10, 2022, 08:31:39 PM by Mr.Pontiac |
|||
th350 valve body spacer plates
Started by stevef |
0 Replies
771 Views |
June 12, 2022, 04:49:21 PM by stevef |
||
5 Replies
2580 Views |
May 24, 2014, 06:28:37 PM by PMD1969 |
|||
16 Replies
2703 Views |
March 18, 2019, 10:57:39 AM by stevef |
|||
length of idle tubes
Started by stevef |
8 Replies
1301 Views |
October 25, 2022, 02:47:05 PM by stevef |
||
Power piston spring recommendation
Started by stevef |
3 Replies
1054 Views |
September 13, 2022, 05:00:40 AM by stevef |
Normal Topic
Hot Topic (More than 10 replies)
Very Hot Topic (More than 20 replies)
Locked Topic
Sticky Topic
Poll