17080213 - correct carb to manifold gasket

[bcarlson78248]

When I pulled my carburetor off to check the float level I realized that the carb to intake gasket I have is one that covers the recessed areas on the front bottom of the carburetor base.  I also noticed in my leftover parts that I have a couple of Quadrajet gaskets that are cut out to uncover this area.

I think the larger coverage gasket was one I got with a rebuild kit I bought from you several years ago, and the cutout gasket may have been the original from my truck, but I'm not sure.   Which gasket should I be using with a 17080213, or does it matter?

I attached a picture (not of my carburetor) where the gasket with a cutout is on the left on the carburetor base, and the larger coverage gasket is shown off to the right. 

Thanks,

Bruce

[Cliff Ruggles]

It really doesn't matter, either one would work fine....

[bcarlson78248]

Thanks,

Bruce

[Cliff Ruggles]

For Chevy carburetors 1971 thru 1979 I include the type on the left in our rebuild kits.  For 1980-up I put the type on the right in them. 

If I run out of either one I'll substitute the other as it really doesn't matter and no negatives in actual use from doing so........Cliff