News:
We buy American, and use American Made parts for all of our exclusive Cliff's Carburetor parts and kits.
| Subject / Started by | Replies  / Views |
Last post | ||
|---|---|---|---|---|
|
|
Choke Pull Off For SD-455 Carburetors
Started by Brian B. |
1 Replies
2923 Views |
October 19, 2011, 03:40:48 AMby Cliff Ruggles |
|
|
|
1 Replies
2570 Views |
May 08, 2012, 04:19:42 AM by Cliff Ruggles |
|
|
|
|
Big Thanks to Cliff
Started by redman76 |
1 Replies
2463 Views |
May 04, 2012, 04:11:40 AM by Cliff Ruggles |
|
|
|
Gas in Vac Port
Started by JMac11 |
1 Replies
2712 Views |
November 04, 2011, 05:40:49 AM by Cliff Ruggles |
|
|
|
Base Plate
Started by Paul |
1 Replies
2819 Views |
March 30, 2011, 07:48:18 PM by Cliff Ruggles |
|
|
|
Quadrajet for marine engine
Started by Bob1966 |
1 Replies
3055 Views |
April 16, 2012, 04:36:47 AM by Cliff Ruggles |
|
|
|
1985 non electronic mopar Q-jet found.
Started by omaha |
1 Replies
3094 Views |
November 06, 2010, 03:31:24 AM by Cliff Ruggles |
|
|
|
Is clip mandatory on needle ?
Started by Frank400 |
1 Replies
3181 Views |
May 04, 2012, 04:14:23 AM by Cliff Ruggles |
|
|
|
1 Replies
2862 Views |
February 20, 2012, 04:03:05 AM by Cliff Ruggles |
|
|
|
|
Fuel ratio & float level
Started by 77cruiser |
1 Replies
3281 Views |
May 13, 2010, 05:15:03 AM by Cliff Ruggles |
|
|
|
ULTRASONIC CLEANERS
Started by billy 2 |
1 Replies
3321 Views |
May 09, 2010, 03:58:09 AM by Cliff Ruggles |
|
|
|
Removing Primary Shaft Screws
Started by von |
1 Replies
3026 Views |
May 08, 2010, 05:05:19 AM by billy 2 |
|
|
|
quadrajet identification.
Started by xc250 |
1 Replies
3246 Views |
March 06, 2012, 09:58:55 PM by Ethan1 |
|
|
|
lower airbleeds
Started by horsepowerfreek |
1 Replies
2735 Views |
January 25, 2012, 10:03:19 PM by Ethan1 |
|
|
|
Just wanted to share...
Started by Marx3 |
1 Replies
3255 Views |
April 24, 2010, 12:53:05 PM by Cliff Ruggles |
|
|
|
1 Replies
3248 Views |
April 22, 2010, 04:51:07 AM by Cliff Ruggles |
|
|
|
|
Too Large Idle Channel Restriction?
Started by von |
1 Replies
3916 Views |
April 22, 2010, 04:47:27 AM by Cliff Ruggles |
|
|
|
1 Replies
2989 Views |
December 06, 2011, 03:23:16 AM by Cliff Ruggles |
|
|
|
|
carb recolor
Started by jjr |
1 Replies
3363 Views |
December 29, 2011, 03:55:08 AM by Cliff Ruggles |
|
|
|
Nozzle drip
Started by Paul |
1 Replies
3645 Views |
April 04, 2011, 04:49:00 PM by Cliff Ruggles |
Normal Topic
Hot Topic (More than 10 replies)
Very Hot Topic (More than 20 replies)
Locked Topic
Sticky Topic
Poll