Quadrajet Problem Solving > Buy Quadrajet Parts, Quadrajet Kits, Service
Quadrajet Carb 7036202 C6 DH
Cliff Ruggles:
The cup plugs spin out pretty easily. Never ran into a set yet that gave much trouble....Cliff
twilloug:
I have a few parts in the kit that I am not sure where they go. I have a pretty good grasp on the upgraded needle and seat. (Brass piece with gasket, hold down ring and two screws.) But what is the smaller brass piece with the O ring on it? I searched the forums and you say it is the O ring fuel inlet plug. Where does it go?
Also, what is the small black rubber cap with plug? small cork gasket? Will try to post pics too. thanks
Cliff Ruggles:
Brass peice with "O" ring is to plug the bypass just to the left of the needle/seat assembly.
Rubber cap is for the front vent.
Cork gasket for the HIC in the rear of the main casting under the cover.
....Cliff
twilloug:
Cliff can you clarify something for me on the gaskets you sent for carb to intake and body to throttle plate. I had installed the thin black gasket between the carb and intake but it was setup for manifold exhaust heat with an opening in front of primaries. This was creating a vacuum leak. Now I am questioning the purple gasket that I installed between the throttle plate and body. it is 1/4" thick...
Is the purple gasket the right one for throttle plate to body? I bought another carb to manifold gasket...
Cliff Ruggles:
If used on an original intake, the gasket with the cut out goes down first, then a stainless steel shim gasket, then the carburetor......Cliff
Navigation
[0] Message Index
[#] Next page
[*] Previous page
Go to full version